Kamis, 22 Desember 2011

CNN1.0(1000l/h)

IDR 000.00







TRANSFORMER OIL PURIFICATION PLANT

CMM-1.0(1000 l/h)


· Dehydration, degassing and filtration of oil
· On site drying of transformer with simultaneous treatment of the oil
· First filling of electrical apparatuses with insulating oil


APPLICATION


CMM systems serve for degasification, dehydration and filtration of transformer, cable, turbine and other oils for removal of gases, free and soluble water and particulate matter. The system is applied while installation, repair and operating of oil-filled high voltage equipment (power transformers, high-voltage switches etc.) as well as turbines. Most frequently encountered contaminants in oil are water, gases and solids. These contaminants are detrimental to the performance and life of the oil. CMM oil purification plant is fully acceptable
for the following oils:
• Insulating (Transformer Oils)
• Lubricating Oils
• Turbine Oils
• Compressor Seal Oils
• Synthetic Fluids
• Quenching Oils
• Cutting and Cooling Mineral Oils
Operational conditions:
• Oil viscosity must not exceed 70 centistokes at 50oC.
• Atmospheric pressure from 84 to 106.7 kPa (630 to 830 cm. hg.);
• Height above mean sea level up to 2000 m;

Benefit

Every company dealing with oil-insulated high voltage equipment (transformers, high-voltage switches, turbines, etc., share the problem of change or disposal of contaminated oils. Costs of disposal or changing of insulating oils are frequently very high and need a significant investment. Our equipment offers a practical, proven and economical method to purify the oil and use it again for high voltage equipment. Thermally accelerated Vacuum Dehydration and Degasification of Transformer Oil has gained wide acceptance as the most economical method for the removal of dissolved water and gases. On-Site Transformer Oil Purification is the most profitable as not only does it purify the oil within the transformer, but it actively regenerates the Transformer by removing impurities which buildup within the transformer.

SHORT PROCESS DESCRIPTION


Filtration mode

Gear pump sucks the oil for processing via valve and strainer. Processed oil is then pumpedthrough cartridge filter, three-way valve and is discharged to processed oil vessel via connector.

Hot filtration and thermo-vacuum drying

Gear pump sucks the oil for processing via strainer and cartridge filter and directs it to the heat exchanger, where the oil is heated by the circulating heat conductor. The oil is fed to the vacuum drier’s sprayer after being heated to 60oC. Vacuum pump maintains vacuum in the vacuum chamber. Vacuum can be regulated by valve and monitored on the vacuum meter. Filtered hot air comes into the chamber and removes gases and vapor from the oil’s surface, drying the oil. The air is then discharged into the atmosphere via oil separator by the vacuum pump. Gear pump directs the oil into the processed oil vessel. A programmable thermal regulator switch monitors the plant’s function continuously and maintains the pre-set temperature.

Dimensions

Length, mm 1400
Width, mm 1800
Height, mm 800
Weight, kg 520

PRODUCED BY GLOBALCORE - UKRAINA
PC GlobeCore Sadovskogo 8
Poltava, Ukraine

Add to Cart

0 komentar:

Posting Komentar